Is your Kenmore refrigerator ice maker not working? Before you assume the worst, know this: most "dead" Kenmore ice makers are fixed in under an hour. The usual culprits are a failed ice maker module, a bad water inlet valve, a clogged water filter, or a freezer that's running too warm. Stockton Refrigerator Repair diagnoses and fixes Kenmore ice makers the same day across Stockton and the Central Valley. Handy with tools? Shop genuine Kenmore ice maker parts in our store.
Why Your Kenmore Refrigerator Ice Maker Is Not Working
- Failed ice maker module — the most common cause; the module's motor or thermostat wears out and it stops cycling.
- Bad water inlet valve — if the valve doesn't open, no water reaches the mold. Often the water dispenser still works while ice production dies.
- Freezer too warm — the ice maker needs the freezer at 0–5°F. Anything above 10°F and ice production stalls.
- Clogged or overdue water filter — restricted flow starves the ice maker; replace the filter every 6 months.
- Frozen or kinked water line — blocks water from reaching the ice maker entirely.
- Faulty control board — less common, but a dead board can cut power to the ice maker circuit.
Quick Checks Before You Call
- Confirm the ice maker is switched ON and the bail arm isn't stuck in the "up" position.
- Check the freezer temperature — it should read 0–5°F.
- Replace the water filter if it's older than 6 months.
- Make sure the water supply valve behind the fridge is fully open and the line isn't kinked.
If ice still isn't being made after these checks, the module or inlet valve has likely failed — that's a job for a technician. Call (209) 565-0006 and we'll fix it the same day.
Our Kenmore Ice Maker Repair Process
- Same-day diagnosis — we test the module, valve, water supply, and freezer temperature to isolate the fault.
- Upfront flat quote — one clear price, approved before any work starts.
- Genuine Kenmore parts — factory ice maker assemblies and valves, usually installed on the spot.
- Verified ice production — we confirm the ice maker cycles and fills before leaving, backed by our workmanship warranty.
Service Areas
We fix Kenmore ice makers in Stockton, Lodi, Manteca, Lathrop, Tracy, and Modesto.
Kenmore Ice Maker Not Working — FAQ
How do I reset my Kenmore ice maker?
Many Kenmore models reset by turning the ice maker off for 30 seconds, then back on — or by pressing the reset button on the module. If it doesn't start cycling within 24 hours, the module has likely failed.
Why is my Kenmore ice maker not making ice but the water dispenser works?
The ice maker and dispenser use separate sides of the water inlet valve. A valve that feeds the dispenser can still fail on the ice maker side — or the module itself is dead.
How much does it cost to fix a Kenmore ice maker that's not working?
Most repairs cost $150–$400 including parts and labor. A full ice maker assembly replacement is at the higher end.
Should I repair or replace my Kenmore refrigerator?
If the fridge cools properly and is under 12–15 years old, repairing the ice maker is far cheaper than replacing the whole refrigerator.
Do you guarantee the repair?
Yes — every Kenmore ice maker repair includes our written workmanship warranty plus the manufacturer's part warranty.
Related Services
See Kenmore ice maker repair, Sub-Zero repair near me, Bull refrigerator repair, and our guide on why a refrigerator ice maker stops working.
Kenmore ice maker not working? Call (209) 565-0006 for same-day repair in Stockton, CA.